From: Tom Rini Date: Wed, 29 Jul 2020 09:43:15 -0400 Subject: [PATCH] pinctrl: mediatek: add PUPD/R0/R1 support for MT7623 In-Reply-To: <0ca9df6ed386ba064ff4ca4c67d3a467dd79aa21.camel@infradead.org> References: <67818497faeb00fc82af639ad29536406b29dbd8.camel@infradead.org> <0f643138d106b75df6c66b52607f21def681d9e1.camel@infradead.org> <433a7e49d0436bb4faad5abd36fca3276b253779.camel@infradead.org> <0965610b1daeb5884a2e71a115c716521c45abca.camel@infradead.org> <0ca9df6ed386ba064ff4ca4c67d3a467dd79aa21.camel@infradead.org> Message-ID: <20200729134315.GK6965@bill-the-cat> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de On Fri, Jun 19, 2020 at 12:40:20PM +0100, David Woodhouse wrote: > The pins for the MMC controller weren't being set up correctly because the > pinctrl driver only sets the GPIO pullup/pulldown config and doesn't > handle the special cases with PUPD/R0/R1 control. > > Signed-off-by: David Woodhouse > Tested-By: Frank Wunderlich Applied to u-boot/master, thanks! -- Tom -------------- next part -------------- A non-text attachment was scrubbed... Name: signature.asc Type: application/pgp-signature Size: 659 bytes Desc: not available URL: