From: Jeremy Kerr Date: Fri, 11 Sep 2020 09:51:05 +0800 Subject: [PATCH v2 2/2] gpio/aspeed-sgpio: don't enable all interrupts by default In-Reply-To: <20200911015105.48581-1-jk@codeconstruct.com.au> References: <20200911015105.48581-1-jk@codeconstruct.com.au> Message-ID: <20200911015105.48581-2-jk@codeconstruct.com.au> List-Id: To: linux-aspeed@lists.ozlabs.org MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit Currently, the IRQ setup for the SGPIO driver enables all interrupts in dual-edge trigger mode. Since the default handler is handle_bad_irq, any state change on input GPIOs will trigger bad IRQ warnings. This change applies sensible IRQ defaults: single-edge trigger, and all IRQs disabled. Signed-off-by: Jeremy Kerr Fixes: 7db47faae79b ("gpio: aspeed: Add SGPIO driver") --- v2: - update comments to reflect trigger mode change - tweak wording to reflect disabled state & single-edge trigger mode --- drivers/gpio/gpio-aspeed-sgpio.c | 8 +++----- 1 file changed, 3 insertions(+), 5 deletions(-) diff --git a/drivers/gpio/gpio-aspeed-sgpio.c b/drivers/gpio/gpio-aspeed-sgpio.c index a18ca52432e0..64e54f8c30d2 100644 --- a/drivers/gpio/gpio-aspeed-sgpio.c +++ b/drivers/gpio/gpio-aspeed-sgpio.c @@ -452,17 +452,15 @@ static int aspeed_sgpio_setup_irqs(struct aspeed_sgpio *gpio, irq->parents = &gpio->irq; irq->num_parents = 1; - /* set IRQ settings and Enable Interrupt */ + /* Apply default IRQ settings */ for (i = 0; i < ARRAY_SIZE(aspeed_sgpio_banks); i++) { bank = &aspeed_sgpio_banks[i]; /* set falling or level-low irq */ iowrite32(0x00000000, bank_reg(gpio, bank, reg_irq_type0)); /* trigger type is edge */ iowrite32(0x00000000, bank_reg(gpio, bank, reg_irq_type1)); - /* dual edge trigger mode. */ - iowrite32(0xffffffff, bank_reg(gpio, bank, reg_irq_type2)); - /* enable irq */ - iowrite32(0xffffffff, bank_reg(gpio, bank, reg_irq_enable)); + /* single edge trigger */ + iowrite32(0x00000000, bank_reg(gpio, bank, reg_irq_type2)); } return 0; -- 2.28.0