From: Jason Wessel Date: Sun, 13 Sep 2020 19:39:18 -0700 Subject: [PATCH v2 1/4] xhci.c: Add retry in xhci_address_device() In-Reply-To: <20200914023921.119630-1-jason.wessel@windriver.com> References: <20200914023921.119630-1-jason.wessel@windriver.com> Message-ID: <20200914023921.119630-2-jason.wessel@windriver.com> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de After a port reset some usb keyboard devices do not respond immediately, and instead the controller reports COMP_TX_ERR. Adding a retry after the first TX error is returned resolves the issue. Without the patch u-boot prints: Starting the controller USB XHCI 1.00 scanning bus xhci_pci for devices... Device not responding to set address. USB device not accepting new address (error=80000000) Signed-off-by: Jason Wessel --- drivers/usb/host/xhci.c | 9 +++++++++ 1 file changed, 9 insertions(+) diff --git a/drivers/usb/host/xhci.c b/drivers/usb/host/xhci.c index 126dabc11b..9a31eba2bb 100644 --- a/drivers/usb/host/xhci.c +++ b/drivers/usb/host/xhci.c @@ -675,6 +675,7 @@ static int xhci_address_device(struct usb_device *udev, int root_portnr) struct xhci_virt_device *virt_dev; int slot_id = udev->slot_id; union xhci_trb *event; + int retry_cnt = 0; virt_dev = ctrl->devs[slot_id]; @@ -685,6 +686,7 @@ static int xhci_address_device(struct usb_device *udev, int root_portnr) debug("Setting up addressable devices %p\n", ctrl->dcbaa); xhci_setup_addressable_virt_dev(ctrl, udev, root_portnr); +retry: ctrl_ctx = xhci_get_input_control_ctx(virt_dev->in_ctx); ctrl_ctx->add_flags = cpu_to_le32(SLOT_FLAG | EP0_FLAG); ctrl_ctx->drop_flags = 0; @@ -701,6 +703,13 @@ static int xhci_address_device(struct usb_device *udev, int root_portnr) ret = -EINVAL; break; case COMP_TX_ERR: + retry_cnt++; + if (retry_cnt < 2) { + /* Retry in case this was just after a port reset */ + debug("COMP_TX_ERR retry\n"); + xhci_acknowledge_event(ctrl); + goto retry; + } puts("Device not responding to set address.\n"); ret = -EPROTO; break; -- 2.17.1