From: peng.fan at nxp.com Date: Wed, 16 Sep 2020 20:56:59 +0800 Subject: [PATCH 07/13] usb: ehci-mx6: Enable iMX EHCI driver for iMX8M Nano In-Reply-To: <20200916125705.4341-1-peng.fan@nxp.com> References: <20200916125705.4341-1-peng.fan@nxp.com> Message-ID: <20200916125705.4341-8-peng.fan@nxp.com> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de From: Ye Li Add the IMX8MN to the EHCI-MX7 kconfig dependency. Signed-off-by: Ye Li Signed-off-by: Peng Fan --- drivers/usb/host/Kconfig | 2 +- drivers/usb/host/ehci-mx6.c | 2 +- 2 files changed, 2 insertions(+), 2 deletions(-) diff --git a/drivers/usb/host/Kconfig b/drivers/usb/host/Kconfig index 1e2c5006d4..36eb1138c4 100644 --- a/drivers/usb/host/Kconfig +++ b/drivers/usb/host/Kconfig @@ -147,7 +147,7 @@ config USB_EHCI_MX6 config USB_EHCI_MX7 bool "Support for i.MX7 on-chip EHCI USB controller" - depends on ARCH_MX7 || IMX8MM + depends on ARCH_MX7 || IMX8MM || IMX8MN default y ---help--- Enables support for the on-chip EHCI controller on i.MX7 SoCs. diff --git a/drivers/usb/host/ehci-mx6.c b/drivers/usb/host/ehci-mx6.c index 96dcf7655b..ca015ef2f3 100644 --- a/drivers/usb/host/ehci-mx6.c +++ b/drivers/usb/host/ehci-mx6.c @@ -598,7 +598,7 @@ static int ehci_usb_phy_mode(struct udevice *dev) plat->init_type = USB_INIT_DEVICE; else plat->init_type = USB_INIT_HOST; - } else if (is_mx7() || is_imx8mm()) { + } else if (is_mx7() || is_imx8mm() || is_imx8mn()) { phy_status = (void __iomem *)(addr + USBNC_PHY_STATUS_OFFSET); val = readl(phy_status); -- 2.28.0