From: sbabic at denx.de Date: Fri, 18 Sep 2020 16:06:32 +0200 (CEST) Subject: [PATCH v3] mmc: fsl_esdhc_imx: check the clock stable status after config the clock rate. In-Reply-To: <1598945646-7009-1-git-send-email-haibo.chen@nxp.com> Message-ID: <20200918140632.6AE70824D5@phobos.denx.de> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de > From: Haibo Chen > Currently, after config the clock rate, delay 10ms, this is quite a rough > method. Check the clock stable status in the present status register is > enough. > Tested-by: Ji Luo > Signed-off-by: Haibo Chen Applied to u-boot-imx, master, thanks ! Best regards, Stefano Babic -- ===================================================================== DENX Software Engineering GmbH, Managing Director: Wolfgang Denk HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de =====================================================================