From: Michael Walle Date: Wed, 23 Sep 2020 12:42:46 +0200 Subject: [PATCH 0/6] mmc: fsl_esdhc: add ADMA2 support Message-ID: <20200923104252.14919-1-michael@walle.cc> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de Add ADMA2 support mainly because it supports 64bit DMA addresses. These are for example used if you use EFI on a LS1028A board which has more than 2GB of RAM, because only the lower 2GB are mapped into the lower 32bit address space. Patches 1-4 clean the fsl_esdhc driver up. Patch 5 moves ADMA2 table handling code out of the sdhci core code. Patch 6 finally adds the ADMA2 support to the fsl_esdhc driver. This was tested on a custom board LS1028A board. A passing travis-ci build is available at: https://travis-ci.org/github/mwalle/u-boot/builds/729431087 Michael Walle (6): mmc: fsl_esdhc: simplify 64bit check for SDMA transfers mmc: fsl_esdhc: use dma-mapping API mmc: fsl_esdhc: simplify esdhc_setup_data() mmc: fsl_esdhc: replace most #ifdefs by IS_ENABLED() mmc: sdhci: move the ADMA2 table handling into own module mmc: fsl_esdhc: add ADMA2 support drivers/mmc/Kconfig | 13 ++ drivers/mmc/Makefile | 1 + drivers/mmc/fsl_esdhc.c | 267 ++++++++++++++++++++------------------- drivers/mmc/sdhci-adma.c | 73 +++++++++++ drivers/mmc/sdhci.c | 63 ++------- include/fsl_esdhc.h | 14 ++ include/sdhci.h | 8 +- 7 files changed, 252 insertions(+), 187 deletions(-) create mode 100644 drivers/mmc/sdhci-adma.c -- 2.20.1