From: Thomas Petazzoni Date: Sun, 27 Sep 2020 11:57:01 +0200 Subject: [Buildroot] [PATCH 1/1] configs/stm32mp157c_dk2_trusted_defconfig: new platform In-Reply-To: <20200927061606.10239-1-shlomi.39sd@gmail.com> References: <20200927061606.10239-1-shlomi.39sd@gmail.com> Message-ID: <20200927115701.520b50a6@windsurf.hq.k.grp> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: buildroot@busybox.net Hello Shlomi, +Bartosz in Cc. Thanks for your contribution. On Sun, 27 Sep 2020 09:16:06 +0300 Shlomi Vaknin wrote: > Adding support for trusted configuration for stm32mp157c-dk2. > In addtion, the following changes made to the original stm32mp157c_dk2_defconfig: > 1. Enable gadget support and wifi support in `linux.config`. > 2. Create a new dts file that contains the bindings for the wifi module. This was > copied from the stm32 kernel fork. > 3. A txt file for the wifi firmware. This was copied from the yocto bsp layer of st. > > Signed-off-by: Shlomi Vaknin I am not sure it makes sense to have a separate defconfig for this. The ATF-based boot is really the one recommended by ST, and it's also the only one that allows to use the STM32 Cube Programmer for flashing. So I would rather suggest that we change the existing stm32mp1 defconfigs (both DK1 and DK2) to use ATF instead of U-Boot SPL. Bartosz, what do you think ? Thomas -- Thomas Petazzoni, CTO, Bootlin Embedded Linux and Kernel engineering https://bootlin.com