From: Marek Vasut Date: Tue, 1 Dec 2020 11:29:19 +0100 Subject: [PATCH 3/4] ARM: dts: stm32: Enable SDMMC3 on DH DRC02 In-Reply-To: <20201201102920.84051-1-marex@denx.de> References: <20201201102920.84051-1-marex@denx.de> Message-ID: <20201201102920.84051-3-marex@denx.de> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de The DH DRC02 board has an on-board microSD slot, add DT properties to enable the slot. Signed-off-by: Marek Vasut Cc: Patrice Chotard Cc: Patrick Delaunay --- NOTE: Large part of this should be in the DHCOM SoM DT, however a DT sync should only happen after Linux 5.10.y and U-Boot 2021.01 are out. --- arch/arm/dts/stm32mp15xx-dhcom-drc02.dts | 13 +++++++++++-- 1 file changed, 11 insertions(+), 2 deletions(-) diff --git a/arch/arm/dts/stm32mp15xx-dhcom-drc02.dts b/arch/arm/dts/stm32mp15xx-dhcom-drc02.dts index 5a237a3b7b..e8508aa4d5 100644 --- a/arch/arm/dts/stm32mp15xx-dhcom-drc02.dts +++ b/arch/arm/dts/stm32mp15xx-dhcom-drc02.dts @@ -105,9 +105,18 @@ * On DRC02, the SoM does not have SDIO WiFi. The pins * are used for on-board microSD slot instead. */ - /delete-property/broken-cd; - cd-gpios = <&gpioi 10 (GPIO_ACTIVE_LOW | GPIO_PULL_UP)>; + pinctrl-names = "default", "opendrain", "sleep"; + pinctrl-0 = <&sdmmc3_b4_pins_a>; + pinctrl-1 = <&sdmmc3_b4_od_pins_a>; + pinctrl-2 = <&sdmmc3_b4_sleep_pins_a>; + cd-gpios = <&gpioi 10 GPIO_ACTIVE_HIGH>; disable-wp; + st,neg-edge; + bus-width = <4>; + vmmc-supply = <&v3v3>; + vqmmc-supply = <&v3v3>; + mmc-ddr-3_3v; + status = "okay"; }; &spi1 { -- 2.29.2