From: sbabic at denx.de Date: Sat, 23 Jan 2021 16:49:46 +0100 (CET) Subject: [PATCH 1/1] arm: dart6ul: enable DM_ETH for the dart6ul In-Reply-To: <20210104154157.116015-1-ferlandm@amotus.ca> Message-ID: <20210123154946.69A2A827FB@phobos.denx.de> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de > From: Marc Ferland > This patch converts the dart6ul ethernet support to DM_ETH and cleans > up the legacy ethernet code. The clean up, more specifically: > * moves the fec2 node and pin definition to the carrier board DTS > since the phy associated with it is on the carrier board and not on > the SoM; > * add the reset pin associated to each phy; > * separate the ethernet, mdio and reset pins of each fec so that they > are easier to reference; > * add clock properties to the phy nodes since they are connected to the > 50Mhz ENET[12]_TX_CLK clock of the SoC; > * remove CONFIG_BOARD_EARLY_INIT_F since the function is now empty. > Signed-off-by: Marc Ferland Applied to u-boot-imx, master, thanks ! Best regards, Stefano Babic -- ===================================================================== DENX Software Engineering GmbH, Managing Director: Wolfgang Denk HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de =====================================================================