From: Tero Kristo Date: Tue, 11 May 2021 11:31:00 +0300 Subject: [PATCHv4 22/26] arm: mach-k3: j721e_init: Force early probe of clk-k3 driver In-Reply-To: <20210511083104.10868-1-kristo@kernel.org> References: <20210511083104.10868-1-kristo@kernel.org> Message-ID: <20210511083104.10868-23-kristo@kernel.org> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de From: Dave Gerlach Force the clk-k3 driver to probe early during R5 SPL boot to ensure the default system clock configuration is completed. Many other drivers assume a default state of the clock tree and it is currently possible for them to probe before clk-k3 depending on the exact system configuration. Signed-off-by: Dave Gerlach Reported-by: Keerthy Tested-by: Keerthy Signed-off-by: Tero Kristo --- arch/arm/mach-k3/j721e_init.c | 12 ++++++++++++ 1 file changed, 12 insertions(+) diff --git a/arch/arm/mach-k3/j721e_init.c b/arch/arm/mach-k3/j721e_init.c index 1a4f796e5e..b5268372dd 100644 --- a/arch/arm/mach-k3/j721e_init.c +++ b/arch/arm/mach-k3/j721e_init.c @@ -180,6 +180,18 @@ void board_init_f(ulong dummy) k3_sysfw_loader(is_rom_loaded_sysfw(&bootdata), k3_mmc_stop_clock, k3_mmc_restart_clock); +#ifdef CONFIG_SPL_CLK_K3 + /* + * Force probe of clk_k3 driver here to ensure basic default clock + * configuration is always done. + */ + ret = uclass_get_device_by_driver(UCLASS_CLK, + DM_DRIVER_GET(ti_clk), + &dev); + if (ret) + panic("Failed to initialize clk-k3!\n"); +#endif + /* Prepare console output */ preloader_console_init(); -- 2.17.1