From: Cédric Le Goater Date: Fri, 4 Mar 2022 09:36:43 +0100 Subject: [PATCH v3 11/11] ARM: dts: aspeed-g4: Set spi-max-frequency for all flashes In-Reply-To: <20220304083643.1079142-1-clg@kaod.org> References: <20220304083643.1079142-1-clg@kaod.org> Message-ID: <20220304083643.1079142-12-clg@kaod.org> List-Id: To: linux-aspeed@lists.ozlabs.org MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit From: Tao Ren Set "spi-max-frequency" to 50 MHz for all the flashes under the FMC controller to ensure the clock frequency is calculated correctly. Suggested-by: C?dric Le Goater Signed-off-by: Tao Ren Signed-off-by: C?dric Le Goater --- arch/arm/boot/dts/aspeed-g4.dtsi | 4 ++++ 1 file changed, 4 insertions(+) diff --git a/arch/arm/boot/dts/aspeed-g4.dtsi b/arch/arm/boot/dts/aspeed-g4.dtsi index 31e6569db97e..d3d919dcb8d4 100644 --- a/arch/arm/boot/dts/aspeed-g4.dtsi +++ b/arch/arm/boot/dts/aspeed-g4.dtsi @@ -72,24 +72,28 @@ flash at 1 { reg = < 1 >; compatible = "jedec,spi-nor"; spi-rx-bus-width = <2>; + spi-max-frequency = <50000000>; status = "disabled"; }; flash at 2 { reg = < 2 >; compatible = "jedec,spi-nor"; spi-rx-bus-width = <2>; + spi-max-frequency = <50000000>; status = "disabled"; }; flash at 3 { reg = < 3 >; compatible = "jedec,spi-nor"; spi-rx-bus-width = <2>; + spi-max-frequency = <50000000>; status = "disabled"; }; flash at 4 { reg = < 4 >; compatible = "jedec,spi-nor"; spi-rx-bus-width = <2>; + spi-max-frequency = <50000000>; status = "disabled"; }; }; -- 2.34.1