From: Greg Patten Subject: Tape (STT8000N) stopped working Date: Wed, 13 Nov 2002 18:32:10 +1100 Sender: linux-scsi-owner@vger.kernel.org Message-ID: <2077.1037172730@iconsult.com.au> Return-path: List-Id: linux-scsi@vger.kernel.org To: linux-scsi@vger.kernel.org Hi all, I've done a fairly exhaustive look over the list and haven't seen anything so I was wondering whether one of you might be able to help me (even tho' my kernel's really old - 2.2.21). This drive has been working for years but I *think* stopped after a recentish kernel upgrade (tho' I'm not entirely convinced). The tape unit is recognised: (scsi0) found at PCI 0/12/0 (scsi0) Narrow Channel, SCSI ID=7, 16/255 SCBs (scsi0) Downloading sequencer code... 415 instructions downloaded scsi0 : Adaptec AHA274x/284x/294x (EISA/VLB/PCI-Fast SCSI) 5.1.33/3.2.4 scsi : 1 host. Vendor: FUJITSU Model: M1606S-512 Rev: 6236 Type: Direct-Access ANSI SCSI revision: 02 Detected scsi disk sda at scsi0, channel 0, id 0, lun 0 (scsi0:0:0:1) Synchronous at 10.0 Mbyte/sec, offset 15. Vendor: QUANTUM Model: FIREBALL1280S Rev: 630C Type: Direct-Access ANSI SCSI revision: 02 Detected scsi disk sdb at scsi0, channel 0, id 1, lun 0 (scsi0:0:1:1) Synchronous at 10.0 Mbyte/sec, offset 8. Vendor: Seagate Model: STT8000N Rev: 4.11 Type: Sequential-Access ANSI SCSI revision: 02 Detected scsi tape st0 at scsi0, channel 0, id 4, lun 0 (scsi0:0:4:1) Synchronous at 10.0 Mbyte/sec, offset 15. scsi : detected 1 SCSI tape 2 SCSI disks total. However if I try and do antything I get an error eg. root@loose 58 ~#mt -f /dev/st0 rewind /dev/st0: I/O error With no tape in the drive I get somewhat encouraging results (however I don't know how to interpret status bits). root@loose 59 ~#mt -f /dev/st0 status SCSI 2 tape drive: File number=-1, block number=-1, partition=0. Tape block size 0 bytes. Density code 0x0 (default). Soft error count since last status=0 General status bits on (50000): DR_OPEN IM_REP_EN but with a tape in the unit I get root@loose 60 ~#mt -f /dev/st0 status SCSI 2 tape drive: File number=-1, block number=-1, partition=0. Tape block size 0 bytes. Density code 0x0 (default). Soft error count since last status=0 General status bits on (10000): IM_REP_EN The unit sounds like it can't access the tape somehow: When I stick a tape in it whirs away for some time with LED flashing (indicates tape is not at 0) before just stopping. Can anyone give me an idea of what might be happening? I'm feeling like the transport's gone or something. Many thanks in advance and sorry for the newbie Q. Cheers, Greg