From: Andy Fleming Date: Tue, 10 Mar 2009 18:06:07 -0500 Subject: [U-Boot] Status open patches: 8xxx In-Reply-To: <20090222000014.08971832E43F@gemini.denx.de> References: <20090222000014.08971832E43F@gemini.denx.de> Message-ID: <2acbd3e40903101606s56eafcedm393c33dd18df552c@mail.gmail.com> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de 8xxx: 12/11 Paul Gortmaker ? ? [U-Boot] [PATCH] tsec: report when there is no vendor specific PHY support. Applied 12/30 Poonam_Aggrwal-b1 ?[U-Boot] [PATCH][u-boot-85xx]The 32bit errata fix for 8572 for DDR2 (fwd) This was applied (e1be0d25ecf494ae81245ca438738ba839d6329b) 01/15 hamoshame Lamotek ?[U-Boot] MPC8572DS Registered DDR2 support. This is just a question thread 02/04 Jon Loeliger ? ? ? Re: [U-Boot] [PATCH 4/8] mpc86xx: Add support to populate addr map based on BATs 02/04 Jon Loeliger ? ? ? Re: [U-Boot] [PATCH 8/8] mpc8641hpcn: Change PCI MEM pci bus address 02/04 Jon Loeliger ? ? ? Re: [U-Boot] [PATCH 1/8] mpc8641hpcn: Set up outbound pci windows before inbound 02/04 Jon Loeliger ? ? ? Re: [U-Boot] [PATCH 5/8] mpc8641hpcn: Clean up PCI mapping concepts All were applied at some point 02/10 "Ajeesh Kumar" ? ? U-boot level MPC8548 Ethernet internal/External Loop back testing Not a patch 02/12 Becky Bruce ? ? ? ?[U-Boot] [PATCH] mpc8641hpcn: Indicate 36-bit addr map in boot messages 02/12 Becky Bruce ? ? ? ?[U-Boot] [PATCH] MPC86xx: set CONFIG_MAX_MEM_MAPPED to 2G by default Both applied already.