From: Robin Gilks Date: Wed, 08 Dec 2004 13:07:14 +1300 Subject: [U-Boot-Users] NC In-Reply-To: <41B6331A.90801@blhealthcare.com> References: <41B6331A.90801@blhealthcare.com> Message-ID: <41B645B2.1040103@tait.co.nz> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de Federico Lucifredi wrote: > Hello U-booters, > This is a quick one: is the network console mechanism bidirectional? > In other words, can I have a full-fledged network-based console or is > the ncb facility only enough to receive bootup messages, but not able to > send them ? I am not quite clear on that from the dox... > > TY -Federico ncb is able to receive only - use the standard netcat utility (nc) to send keyboard data to u-boot. Note - the use of ncb is only necessary if u-boot is configured to send its data as broadcasts. If ncip is defined then use nc both ways. -- Robin Gilks Senior Design Engineer Phone: (+64)(3) 357 1569 Tait Electronics Fax : (+64)(3) 359 4632 PO Box 1645 Christchurch Email : robin.gilks at tait.co.nz New Zealand ======================================================================= This email, including any attachments, is only for the intended addressee. It is subject to copyright, is confidential and may be the subject of legal or other privilege, none of which is waived or lost by reason of this transmission. If the receiver is not the intended addressee, please accept our apologies, notify us by return, delete all copies and perform no other act on the email. Unfortunately, we cannot warrant that the email has not been altered or corrupted during transmission. =======================================================================