From: Andy Furniss Date: Thu, 21 Apr 2005 23:49:42 +0000 Subject: Re: [LARTC] HTB stalling Message-Id: <42683C16.4020504@dsl.pipex.com> List-Id: References: <258b6f705041723197f494890@mail.gmail.com> In-Reply-To: <258b6f705041723197f494890@mail.gmail.com> MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: lartc@vger.kernel.org Krystian Antoni wrote: > Connection is 256kbit/2mbit, but the down interface is used for SMB also so > its shaped from 100mbits. The interfaces are both ethernet. > Number of rules in Iptables is around 300, and I have a new kernel (from > kernel org) and new iptables. > Number of qdisc/class per interface is 7-8. Leaf classes are SFQ. > I tryed: > - running only one part of QOS (down or up) > - puting only minimal set of rules in iptables > - getting kernels from fedora/kernel.org > - reinstalling fedora. > - changing clock from standart to gettimeofday > - changed leaves from SFQ to PRIO > - changed speeds of QOS. > - played with my outside interface from HALF to FULL duplex and reverse way. > and still I had this stalls on the interface which has HTB QoS setup. > Load of my internet connection is around 10%. Propably you're thinking that > I set up my connections parameters too high in QOS, but that is not the case > (I think ;-) since I did a little bit of testing and found out the setting > which alowed me to keep LAN pings through my internet connection even under > heavy load. > CBQ works without any problems. > Computer is 233 MMX with 128 of RAM (36 MB used for system), NIC's are > 3com's 905B and 905C. I dont remember if I tryed changing them :-) > And I dont really now what is that I screw up :-) Wonna see my qos scripts? > :D I use a P200 for a gateway but it's only got one eth card, so I can't really recreate your setup properly - I assume the SMB traffic is forwarded and not local traffic. I can't even do 100Mbit when actually running anything on mine with a rtl8139 - I run out of CPU - doesn't seem to affect internet shaping/throughput. I'll have a go at shaping on eth and see if I can recreate it when I have time. When you say stalls, what happens eg just no throughput or dropped packets or just high latency - is swap being used etc. Andy. _______________________________________________ LARTC mailing list LARTC@mailman.ds9a.nl http://mailman.ds9a.nl/cgi-bin/mailman/listinfo/lartc