From: S. Egbert Date: Wed, 08 Feb 2006 21:42:17 -0800 Subject: [U-Boot-Users] Xilinx ML403/PPC U-Boot support In-Reply-To: <17386.45657.426834.355460@waldo.lisle.iphase.com> References: <43D9E2AB.5020108@sbcglobal.net> <43DEFF49.9090909@xilinx.com> <17386.45657.426834.355460@waldo.lisle.iphase.com> Message-ID: <43EAD639.7000005@sbcglobal.net> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de bbosch at iphase.com wrote: > Peter Ryser writes: > > BTW: you can find a snapshot of U-Boot with board support for ML300, > > ML310, ML403 and ML410 at > > http://www.xilinx.com/ml410-p/designs/u-boot.zip > > The snapshot contains the patches that have been submitted to this > > mailing list back in September of last year. For ML403 just use > > Wolfgang, > > Were the Xilinx patches (2005-09-28 thru 2005-10-02) rejected or lost, > or are they still in your queue? > I'm also interested whether Xilinx EMAC or TEMAC ethernet driver is supported in this...(after reviewing the Xilinx zip file, it doesn't... sigh). However, I do DO have an Ethernet driver for Xilinx EMAC and TEMAC for U-boot and it works... Unfortunately, it uses Xilinx copyrighted codes... Somehow, I doubt this is what you wanted. Is Xilinx copyright ok with you? > Peter, > > Do you happen to have a design for the ML403 that boots directly from > the linear flash? Perhaps with devices mapped as in > board/xilinx/ml403/xparameters.h? It would be easier to start with a > design known to work with U-Boot. > Careful. ML403 reference design (as-is) is not using the Xilinx option of using side-by-side data access (32-bit fetch out of a single 16-bit flash), so XIP (execution in place) is evidently NOT supported in ML403. However, I had a new bit file built with side-by-side data access enabled, but haven't yet execute out of flash (no need because ML403 has a big memory.) But it correctly fetches 32-bit now. Ping me in a week on my progress with XIP and flash. S. Egbert