From: Mirco Fuchs Date: Thu, 06 Jul 2006 08:37:53 +0200 Subject: [U-Boot-Users] MAC address setting In-Reply-To: Message-ID: <44ACCBE1.32244.109A0E@mircofuchs.web.de> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de > Hi all! > > I have custom designed ARM board, based on AT91RM9200EK reference design. > Hardware works fine. > And I have following problem: When U-boot loads Kernel image from tftp, > everything fine. When U-Boot starts kernel from flash, then Linux cannot > communicate to ethernet device. I understand, that this is because MAC > address was not set by U-Boot. But I could not find a command to initialise > Ethernet. I have the same problem with an other AT91RM9200 based board, but this is not an u-boot issue. The kernel driver for the emac should initialize this correctly, but this is obviously not the case. I worked around this problem by doing a ping manually before booting linux or by inserting the eth_init() function call in start_armboot(). Regards Mirco