From: Dmitry Osipenko Subject: Re: [PATCH] sdhci: tegra: Avoid reading autocal timeout values when not applicable Date: Thu, 21 May 2020 15:40:31 +0300 Message-ID: <45c290f9-e276-53be-a7a6-23bf81f50bc3@gmail.com> References: <1590005337-1087-1-git-send-email-skomatineni@nvidia.com> Mime-Version: 1.0 Content-Type: text/plain; charset=utf-8 Content-Transfer-Encoding: 8bit Return-path: In-Reply-To: <1590005337-1087-1-git-send-email-skomatineni-DDmLM1+adcrQT0dZR+AlfA@public.gmane.org> Content-Language: en-US Sender: linux-tegra-owner-u79uwXL29TY76Z2rM5mHXA@public.gmane.org To: Sowjanya Komatineni , adrian.hunter-ral2JQCrhuEAvxtiuMwx3w@public.gmane.org, ulf.hansson-QSEj5FYQhm4dnm+yROfE0A@public.gmane.org, thierry.reding-Re5JQEeQqe8AvxtiuMwx3w@public.gmane.org, jonathanh-DDmLM1+adcrQT0dZR+AlfA@public.gmane.org Cc: linux-tegra-u79uwXL29TY76Z2rM5mHXA@public.gmane.org, linux-kernel-u79uwXL29TY76Z2rM5mHXA@public.gmane.org, linux-mmc-u79uwXL29TY76Z2rM5mHXA@public.gmane.org List-Id: linux-tegra@vger.kernel.org 20.05.2020 23:08, Sowjanya Komatineni пишет: > When auto calibration timeouts, calibration is disabled and fail-safe > drive strength values are programmed based on the signal voltage. > > Different fail-safe drive strength values based on voltage are > applicable only for SoCs supporting 3V3 and 1V8 pad controls. > > So, this patch avoids reading these properties from the device tree > for SoCs not using pad controls and the warning of missing properties > will not show up on these SoC platforms. > > Signed-off-by: Sowjanya Komatineni > --- > drivers/mmc/host/sdhci-tegra.c | 57 ++++++++++++++++++++++++------------------ > 1 file changed, 33 insertions(+), 24 deletions(-) Hello Sowjanya, Thank you for the patch. Tested-by: Dmitry Osipenko