From: MillTek Date: Tue, 12 Feb 2008 16:13:52 +0000 Subject: Re: [lm-sensors] [PATCH] hwmon: (adm1026) Properly terminate sysfs Message-Id: <47B1C5C0.4010902@verizon.net> List-Id: References: <86802c440802092355l7393fe07gfbd021e9cef66181@mail.gmail.com> <20080210171004.GB25353@kroah.com> <20080210190115.2ebd4124@hyperion.delvare> <86802c440802111539w7eeb84dcu97103733364f7a7b@mail.gmail.com> <20080212092722.32c30eac@hyperion.delvare> <20080212152715.GB19441@kroah.com> <20080212163733.461a8684@hyperion.delvare> In-Reply-To: <20080212163733.461a8684@hyperion.delvare> MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: lm-sensors@lm-sensors.org Cc: Yinghai Lu , Linux Kernel Mailing List Hi, Kernel 2.6.24 for my distro (Arch Linux) came out in the last few days. My board has a Fintek F1882g chip. It means that I can finally get voltage and fan speeds for the board, so thanks for that. I am wondering how I correctly calculate the correct offset and factors for the voltage numbers? This is what GKrellm says; Vcor1 1.66 factor 1 offset 0 Vcor2 1.24 factor 1 offset 0 +3.3v 2.83 factor 3 offset 0 +5v 4.82 factor 4.98 offset 0 +12v 3.84 factor 4.0 offset 0 -12v -4.35 factor -4.0 offset 0 -5v -1.51 factor -1.667 offset 0 in7 1.66 factor 1 offset 0 in8 1.54 factor 1 offset 0 If there's a website that I should visit can anyone supply a link?? Jim _______________________________________________ lm-sensors mailing list lm-sensors@lm-sensors.org http://lists.lm-sensors.org/mailman/listinfo/lm-sensors