From: Pieter Date: Thu, 22 Jan 2009 17:08:47 +0200 Subject: [U-Boot] Custom MPC8548 boot using FDT problem Message-ID: <49788BFF.7010207@vastech.co.za> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de Hi all I have been working on booting our custom MPC8548 board using a FDT. The board boots up to the point where "controll is passed to Linux" and then nothing happens. I have plased the final part of the console output at the bottom of this message. Does anyone have an idea about what is going wrong? Is the error in my u-boot, device tree blob or linux kernel side? I am also not able to erase my flash in U-Boot (nor) does anyone know what i should look at? thanks pieter WARNING: adjusting available memory to 10000000 ## Booting kernel from Legacy Image at 00200000 ... Image Name: Linux-2.6.27 Image Type: PowerPC Linux Kernel Image (gzip compressed) Data Size: 1194002 Bytes = 1.1 MB Load Address: 00000000 Entry Point: 00000000 Verifying Checksum ... OK kernel data at 0x00200040, len = 0x00123812 (1194002) ## Flattened Device Tree blob at 00800000 Booting using the fdt blob at 0x800000 of_flat_tree at 0x00800000 size 0x000037bc Uncompressing Kernel Image ... OK kernel loaded at 0x00000000, end = 0x00294a90 ## device tree at 0x00800000 ... 0x008037BB (len=26556=0x67BC) ## Transferring control to Linux (at address 00000000) ... Booting using OF flat tree...