From: Carsten Emde Date: Tue, 18 May 2010 07:01:10 +0000 Subject: Re: [lm-sensors] [PATCH 0/2] hwmon: Update coretemp to current Message-Id: <4BF23B36.7030809@osadl.org> List-Id: References: <20100510035031.GD9181@owl> <20100514065808.GA11598@owl> <20100517094136.094800562@osadl.org> In-Reply-To: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: Dmitry Gromov Cc: Huaxu Wan , Andrew Morton , LKML , LM Sensors Dmitry, >> Here comes the current version of the coretemp patches. Huaxu did the >> initial work; Jean suggested to submit them directly to Andrew. >> >> I made some style changes as advised by checkpatch. >> >> The patches have been tested successfully on Core 2 Duo and Quad, and on >> Nehalem and Nehalem/Westmere where temperature readings were plausible and >> changed with load as expected. When tested on an Atom processor (N270), the >> temperature values were identical to previous versions of the coretemp >> module and also changed with load. However, the readings should be higher >> by 10 to 15C as compared to the outside temperature of the processor. >> Huaxu, could you check? I would guess TjMax to be 105 instead of 90C in these >> processors. > I apologize, if I ask a stupid question, but are you saying that TjMax in > coretemp.c should be set to higher value than Tcase-max value specified in > Intel documents? Hmm, no. I am saying that I would like the reading to be correct. I have measured the outside temperature of the case with an infrared thermometer [1] and found it to be higher than the readings returned by the coretemp module. In all other CPUs I have, the coretemp readings are higher than the case temperature. Carsten. [1] http://www.osadl.org/uploads/media/IPCworld-2008-4.pdf _______________________________________________ lm-sensors mailing list lm-sensors@lm-sensors.org http://lists.lm-sensors.org/mailman/listinfo/lm-sensors