From: cw00.choi@samsung.com (Chanwoo Choi) Date: Fri, 01 Oct 2010 13:07:56 +0900 Subject: [PATCH] ARM: S5PV210: Add audio support to Goni and Aquila board In-Reply-To: References: <4C8D8233.2060602@samsung.com> Message-ID: <4CA55E9C.2020509@samsung.com> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org Jassi Brar wrote: > On Mon, Sep 13, 2010 at 10:45 AM, Chanwoo Choi wrote: >> This patch the I2C board information for the WM8994 used in the Goni/Aquila >> as audio codec and adds the I2C/I2S platform drivers. Additionlly, to >> control power consumption have registerd the voltage consumer of WM8994 >> to the regulator framework. >> >> Additionally, I explain the constraints of the regulator of WM8994 codec. >> All these consumer supply of WM8994 codec connected the regulator(VCC_1.8V) >> on a circuit diagram. "VCC_1.8V" regulator is always enabled, because it is >> used to many devices on Goni/Aquila board. This is required especially >> when there are many devices physically attached to "VCC_1.8V" and some of >> they did not "register" as consumers to "VCC_1.8V". "VCC_1.8V" might be >> turned off by those who are registered while "unregistered" are still active. >> >> Signed-off-by : Chanwoo Choi >> Signed-off-by : Joonyoung Shim >> Signed-off-by : Kyungmin Park >> --- >> arch/arm/mach-s5pv210/mach-aquila.c | 170 +++++++++++++++++++++++++++++++++++ >> arch/arm/mach-s5pv210/mach-goni.c | 157 ++++++++++++++++++++++++++++++++ > > The contents seem ok (at least the audio related). > > But it would have been better if you had broken the patch into three > a) Regulator support adding (90% of the code and should have been > CC'd to Mark and Liam as well) > b) I2C related. > c) Audio related > > Preferably further divided for each machine. > Yes, I will do and resend patch. Thanks Best Regards, Chanwoo Choi