From: cw00.choi@samsung.com (Chanwoo Choi) Date: Mon, 04 Oct 2010 21:50:04 +0900 Subject: [PATCH 3/3] ARM: S5PV210: Add voltage consumer of WM8994 to the regulator framework In-Reply-To: <20101001182752.GD21157@opensource.wolfsonmicro.com> References: <4CA5623D.3000002@samsung.com> <20101001053139.GE30949@sirena.org.uk> <20101001072425.GD20529@opensource.wolfsonmicro.com> <20101001182752.GD21157@opensource.wolfsonmicro.com> Message-ID: <4CA9CD7C.5080907@samsung.com> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org Mark Brown wrote: > On Fri, Oct 01, 2010 at 05:25:43PM +0900, Kyungmin Park wrote: >> On Fri, Oct 1, 2010 at 4:24 PM, Mark Brown > >>> It's still good to show the actual connection on the board for clarity - >>> like I say, the regulator API can handle always on regulators and >>> keeping the regulator setup in software close to the schematic helps >>> make the code easier to follow. > >> It's best but in most case schematic is confidential. so it's impossible. > > Right, this is normal - even with widely available reference boards the > schematics are often distributed only under NDA. Since the information > exposed is at the same level as describing where the devices are on > buses and so on this isn't usually a problem. > >> And as you concerns there's no power issues related with codes. it's >> already verified design. I think wolfsonmicro already confirmed. > > Using a fixed voltage regulator won't cause a problem in operation, the > issue is one of code quality. Hi, Mark. Do you have additional comment on this patch? Best Regards, Chanwoo Choi