From: b32955@freescale.com (Huang Shijie) Date: Tue, 2 Aug 2011 16:22:29 +0800 Subject: [PATCH v8 0/3] add the GPMI controller driver for IMX23/IMX28 In-Reply-To: <20110802081253.GA23380@freescale.com> References: <20110722055731.GI26837@S2100-06.ap.freescale.net> <4E292FCF.6010608@freescale.com> <4E2F6F90.7030207@freescale.com> Message-ID: <4E37B3C5.3050601@freescale.com> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org ? 2011?08?02? 16:12, Shawn Guo ??: > On Tue, Aug 02, 2011 at 02:19:56PM +0800, Huang Shijie wrote: >> Hi, >>> On Fri, Jul 29, 2011 at 11:49 AM, Huang Shijie wrote: >>>> ? 2011?07?29? 15:40, Koen Beel ??: >>>>> Hi, >>>>> >>>>> On Fri, Jul 29, 2011 at 9:20 AM, Lothar Wa?mann >>>>> wrote: >>>>>> Hi, >>>>>> >>>>>> Koen Beel writes: >>>>>>> Hi, >>>>>>> >>>>>>> I have test on mx23evk board. Still see the same issues. >>>>>>> >>>>>>> On Wed, Jul 27, 2011 at 3:53 AM, Huang Shijie >>>>>>> wrote: >>>>>>>> Hi, >>>>>>>> >>>>>>>> Thanks for your test. >>>>>>>> >>>>>>>>> Hi, >>>>>>>>> >>>>>>>>> It's not really working for me. >>>>>>>>> I've applied all gpmi-nand driver patches and the dma driver patches. >>>>>>>>> >>>>>>>>> I have added following kernel parameters: >>>>>>>>> mtdparts=gpmi-nand:20m(boot),-(user) ubi.mtd=1 root=ubi0:rootfs0 >>>>>>>>> rootfstype=ubifs gpmi_debug_init >>>>>>>>> >>>>>>>>> During boot I get already get DMA timeout: >>>>>>>>> [ 2.560000] [ start_dma_without_bch_irq : 392 ] DMA timeout, last >>>>>>>>> DMA >>>>>>>>> :1 >>>>>>>>> [ 3.560000] [ start_dma_with_bch_irq : 427 ] bch timeout!!! >>>>>>>>> ... >>>>>>>>> (see log file in attach line 89) >>>>>>> I still see this DMA timeout when booting. >>>>>>> What kernel parameters do you use? I still use same as above. >>>>>>> >>>>>> Do you have an SD card in the system? I'm getting the same error when >>>>>> accessing an SD card. Without SD card I can use the flash without any >>>>>> errors. >>>>> No SD card in the system. At least not on my mx23evk board. >>>>> My real target hardware has a SDIO wifi chip. >>>> Does it conflict with the GPMI? >>> Well I don't know if it conflicts. From what Lothar says I assume >>> there might be a conflict between gpmi and sdio. >> Yes, the conflict between gpmi and other module(such as SD in MX6Q) >> is THE prime reason >> which caused the DMA timeout. >> >> I am debuging the IMX6Q now, and meet the same problem. >> > I do not follow on this. SD on i.mx6q does not use apbh-dma at all. > How will it conflict with gpmi regarding to dma timeout? > The SD shares the same lines with GPMI, such NANDF_WE/NANDF_RE, NANDF_ALE, NANDF_CS0. If the SD card is working, the GPMI will not. Huang Shijie