From: Zefir Kurtisi Date: Wed, 23 Nov 2011 17:11:44 +0100 Subject: [ath9k-devel] [PATCH 0/2] ath9k: DFS radar detection In-Reply-To: References: <1320770044-12271-1-git-send-email-zefir.kurtisi@neratec.com> <20111115143755.GB2483@tuxdriver.com> Message-ID: <4ECD1B40.1050203@neratec.com> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: ath9k-devel@lists.ath9k.org Luis, any pending concerns or feedback before I start working on v2? Zefir On 11/15/2011 05:46 PM, Luis R. Rodriguez wrote: > On Tue, Nov 15, 2011 at 6:37 AM, John W. Linville > wrote: >> On Tue, Nov 08, 2011 at 05:34:02PM +0100, Zefir Kurtisi wrote: >>> This patch series proposes DFS radar pulse detection for ath9k. >>> >>> The first patch adds a new DFS module, the second turns those >>> knobs to enable the HW to detect radar pulses and forward them >>> to the new module. >>> >>> Here, sanity and plausibility checks that are HW dependent are >>> performed and resulting radar events are passed to higher level >>> generic pattern detectors for further processing (spectrum >>> management, etc.). >>> >>> DFS support is limited to newer chip-sets (for now 9280 and later). >>> >>> So far, AP operation on DFS channels is not supported by >>> mac80211/hostapd. Testing the proposed pulse detection is done in >>> monitor mode. >>> >>> Zefir Kurtisi (2): >>> ath9k: add DFS radar pulse processing >>> ath9k: integrate initial DFS module >> >> Any comments from the ath9k guys on this? > > Just sent my initial set of comments. > > Luis