From: rogerq@ti.com (Roger Quadros) Date: Tue, 5 Feb 2013 10:57:58 +0200 Subject: [PATCH 10/13] ARM: dts: OMAP4: Add HS USB Host IP nodes In-Reply-To: <20130205074141.GB32118@arwen.pp.htv.fi> References: <1359993540-20780-1-git-send-email-rogerq@ti.com> <1359993540-20780-11-git-send-email-rogerq@ti.com> <20130205074141.GB32118@arwen.pp.htv.fi> Message-ID: <5110C996.6020208@ti.com> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org On 02/05/2013 09:41 AM, Felipe Balbi wrote: > On Mon, Feb 04, 2013 at 05:58:57PM +0200, Roger Quadros wrote: >> Adds device nodes for HS USB Host module, TLL module, >> OHCI and EHCI controllers. >> >> Signed-off-by: Roger Quadros >> --- >> arch/arm/boot/dts/omap4.dtsi | 30 ++++++++++++++++++++++++++++++ >> 1 files changed, 30 insertions(+), 0 deletions(-) >> >> diff --git a/arch/arm/boot/dts/omap4.dtsi b/arch/arm/boot/dts/omap4.dtsi >> index 739bb79..3429280 100644 >> --- a/arch/arm/boot/dts/omap4.dtsi >> +++ b/arch/arm/boot/dts/omap4.dtsi >> @@ -529,5 +529,35 @@ >> ti,hwmods = "timer11"; >> ti,timer-pwm; >> }; >> + >> + usbhstll: usbhstll at 0x4a062000 { >> + compatible = "ti,usbhs-tll"; >> + reg = <0x4a062000 0x1000>; >> + interrupts = <0 78 0x4>; >> + ti,hwmods = "usb_tll_hs"; >> + }; >> + >> + usbhshost: usbhshost at 0x4a064000 { >> + compatible = "ti,usbhs-host"; >> + reg = <0x4a064000 0x800>; >> + ti,hwmods = "usb_host_hs"; >> + #address-cells = <1>; >> + #size-cells = <1>; >> + ranges; >> + >> + usbhsohci: ohci at 0x4a064800 { > > usbhsohci is a bit misleading :-) > > How about we stick to ohci and ehci for these nodes ? :-) > Was just thinking of a unique label that will point to the OHCI/EHCI controller in the HS USB subsystem. We need the label to provide PHY information in the board DT. If we are sure we won't have another OHCI/EHCI controller then I can just use ehci/ohci. cheers, -roger