From: sourav.poddar@ti.com (a0131647) Date: Fri, 15 Feb 2013 18:33:58 +0530 Subject: [RFC/RFT PATCH 0/2] SERIAL: OMAP: Remove idle handling from driver In-Reply-To: <1360929970-31934-1-git-send-email-santosh.shilimkar@ti.com> References: <1360929970-31934-1-git-send-email-santosh.shilimkar@ti.com> Message-ID: <511E323E.3050104@ti.com> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org Hi, On Friday 15 February 2013 05:36 PM, Santosh Shilimkar wrote: > OMAP UART IP needs manual idle modes based on state of the > IP. Currently this is handled by the driver with function pointers > implemented in platform code. > > This however breaks in case of device tree because of missing > idle handling. > > The series tries to address the issue > > Patches has been tested on OMAP4 and OMAP5 devices where the console > slugishness was observed without idle mode handling. CPUIDLE and > suspend tested ok on these devices. > > Need help in testing on OMAP2, OMAP3 and AM3XXX devices. > Tested this series on omap3630 beagle board for: 1. Retention in idle and suspend. 2. Off mode in idle and suspend. Tested-by: Sourav Poddar > Santosh Shilimkar (2): > ARM: OMAP2+: hwmod-data: UART IP needs software control of sidle > modes > SERIAL: OMAP: Remove the idle handling from the driver > > arch/arm/mach-omap2/omap_hwmod_2xxx_ipblock_data.c | 3 ++ > arch/arm/mach-omap2/omap_hwmod_33xx_data.c | 6 ++++ > arch/arm/mach-omap2/omap_hwmod_3xxx_data.c | 4 +++ > arch/arm/mach-omap2/omap_hwmod_44xx_data.c | 6 +++- > arch/arm/mach-omap2/serial.c | 31 -------------------- > drivers/tty/serial/omap-serial.c | 23 --------------- > 6 files changed, 18 insertions(+), 55 deletions(-) >