From: nsekhar@ti.com (Sekhar Nori) Date: Thu, 28 Feb 2013 16:09:47 +0530 Subject: [PATCH] ARM: davinci: da850 evm: update clock rate for UART 1/2 DT nodes In-Reply-To: <1361262734-8540-1-git-send-email-prakash.pm@ti.com> References: <1361262734-8540-1-git-send-email-prakash.pm@ti.com> Message-ID: <512F33F3.9070203@ti.com> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org Prakash, On 2/19/2013 2:02 PM, Manjunathappa, Prakash wrote: > DT kernel with latest of denx SPL U-boot boots with garbled UART > logs. This is because in U-boot UART2 gets sourced by PLL0_SYSCLK2 > configured for 150MHz. But later in kernel UART2 gets mapped to > PLL1_SYSCLK2 and is configured for 132MHz not for 150MHz. > > PLL1 is configured for 264MHz to support mDDR on the EVM. That is > memory controller driving mDDR can be configured for 150MHz and > mDDR it self can operate at 132MHz. > > So override UART1 and UART2 DT node clock-frequency property with > rate available on da850 EVM. > > Signed-off-by: Manjunathappa, Prakash How about dropping the clock-frequency attribute altogether? of_serial.c seems to be falling back on clk apis if frequency is not passed and that should make the kernel work with all versions of U-Boot. Thanks, Sekhar > --- > arch/arm/boot/dts/da850-evm.dts | 2 ++ > 1 files changed, 2 insertions(+), 0 deletions(-) > > diff --git a/arch/arm/boot/dts/da850-evm.dts b/arch/arm/boot/dts/da850-evm.dts > index f712fb6..c359872 100644 > --- a/arch/arm/boot/dts/da850-evm.dts > +++ b/arch/arm/boot/dts/da850-evm.dts > @@ -22,9 +22,11 @@ > status = "okay"; > }; > serial1: serial at 1d0c000 { > + clock-frequency = <132000000>; > status = "okay"; > }; > serial2: serial at 1d0d000 { > + clock-frequency = <132000000>; > status = "okay"; > }; > rtc0: rtc at 1c23000 { >