From: nsekhar@ti.com (Sekhar Nori) Date: Thu, 14 Mar 2013 16:38:09 +0530 Subject: [PATCH v5 1/4] ARM: davinci: mmc: derive version information from device name In-Reply-To: <1363097637-11371-2-git-send-email-prakash.pm@ti.com> References: <1363097637-11371-1-git-send-email-prakash.pm@ti.com> <1363097637-11371-2-git-send-email-prakash.pm@ti.com> Message-ID: <5141AF99.5090608@ti.com> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org Prakash, The series looks good to me. I tested it again on DA850 EVM (with and without DT). On 3/12/2013 7:43 PM, Manjunathappa, Prakash wrote: > Remove specifying mmc controller IP version information via platform > data, instead specify device name so that driver derives it from > platform_device_id table. Also change the clock node name to match > the changed dev_id. > Tested on da850-evm to make sure driver loads without clk_get failures. > > Signed-off-by: Manjunathappa, Prakash > Reviewed-by: Sekhar Nori > --- > diff --git a/drivers/mmc/host/davinci_mmc.c b/drivers/mmc/host/davinci_mmc.c > index 27123f8..50e9782 100644 > --- a/drivers/mmc/host/davinci_mmc.c > +++ b/drivers/mmc/host/davinci_mmc.c > @@ -1157,6 +1157,18 @@ static void __init init_mmcsd_host(struct mmc_davinci_host *host) > mmc_davinci_reset_ctrl(host, 0); > } > > +static struct platform_device_id davinci_mmc_devtype[] = { > + { > + .name = "davinci-mmc-dm355", > + .driver_data = MMC_CTLR_VERSION_1, > + }, { > + .name = "davinci-mmc-da830", > + .driver_data = MMC_CTLR_VERSION_2, > + }, > + {}, > +}; > +MODULE_DEVICE_TABLE(platform, davinci_mmc_devtype); I should have mentioned this previously, but your choice of name here is too long. You can simply use dm355-mmc (rather dm6441-mmc?) and da830-mmc instead like you did for SPI. This would have saved some long lines. Sorry about not asking for this earlier. I know it would have saved you a bunch of effort. Thanks, Sekhar