From: kishon@ti.com (Kishon Vijay Abraham I) Date: Tue, 28 May 2013 10:48:02 +0530 Subject: [RFC PATCH 1/4] arm: omap: Add phy binding info for musb in plat data In-Reply-To: <1368796954-3499-1-git-send-email-kishon@ti.com> References: <1368796954-3499-1-git-send-email-kishon@ti.com> Message-ID: <51A43E0A.8090201@ti.com> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org Hi Tony, On Friday 17 May 2013 06:52 PM, Kishon Vijay Abraham I wrote: > In order for controllers to get PHY in case of non dt boot, the phy > binding information (phy label) should be added in the platform > data of the controller. This series would be needed to get MUSB working in OMAP3 boards for non-dt boot case. Do you think this is good enough to go in this rc cycle? Thanks Kishon