From: kishon@ti.com (Kishon Vijay Abraham I) Date: Fri, 14 Jun 2013 11:05:44 +0530 Subject: [RFC PATCH 1/4] arm: omap: Add phy binding info for musb in plat data In-Reply-To: <51B9C3B6.1080707@ti.com> References: <1368796954-3499-1-git-send-email-kishon@ti.com> <51A43E0A.8090201@ti.com> <51B9C3B6.1080707@ti.com> Message-ID: <51BAABB0.5060107@ti.com> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org Hi, On Thursday 13 June 2013 06:35 PM, Tomi Valkeinen wrote: > Hi, > > On 28/05/13 08:18, Kishon Vijay Abraham I wrote: >> Hi Tony, >> >> On Friday 17 May 2013 06:52 PM, Kishon Vijay Abraham I wrote: >>> In order for controllers to get PHY in case of non dt boot, the phy >>> binding information (phy label) should be added in the platform >>> data of the controller. >> >> This series would be needed to get MUSB working in OMAP3 boards for >> non-dt boot case. Do you think this is good enough to go in this rc cycle? > > Did this or some other solution go forward? I'm still unable to boot > with usb-gadget-ethernet with v3.10-rc5. No. I think Tony is ok to take this only during next merge window. Thanks Kishon