From: Chris Rodley Date: Thu, 29 Aug 2013 21:58:10 +0000 Subject: Re: [lm-sensors] sht15 kernel driver Message-Id: <521FC3F2.5030504@snapithd.com> List-Id: References: <521E7CA7.5060407@snapithd.com> <87fvtt4dmt.fsf@jerows.sfl> <521EBD9F.7070502@snapithd.com> <87ppswh75z.fsf@jerows.sfl> In-Reply-To: <87ppswh75z.fsf@jerows.sfl> MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: Jerome Oufella Cc: kernel@savoirfairelinux.com, linux-kernel@vger.kernel.org, lm-sensors@lm-sensors.org On 30/08/13 03:02, Jerome Oufella wrote: > Chris Rodley writes: >> Thanks Jerome! >> >> That was just what I needed to know. >> The device is now set up and is working well - I will have a go at >> back porting now. >> >> Many thanks again for your help! >> Chris > Good to know Chris! > > Note, we noticed that the sht15 driver may be sensible to noisy lines, > we suspect a race condition around the interrupt handling code. > > If your sensor is populated on the board you shouldn't have problems > though. > > Jerome Hi, We have it working really well .. not noticing any issues - so far at least. It is being populated more or less directly on the board - just via a daughter board in the prototype phase. So I might not see the same issues. If we find anything I will submit it back to you. Many thanks again for your advice! Chris _______________________________________________ lm-sensors mailing list lm-sensors@lm-sensors.org http://lists.lm-sensors.org/mailman/listinfo/lm-sensors