From: bcousson@baylibre.com (Benoit Cousson) Date: Tue, 24 Sep 2013 11:41:21 +0200 Subject: [PATCH 2/2] ARM: dts: dra7-evm: Add mmc2 node for eMMC support In-Reply-To: <1377525218-7655-3-git-send-email-balajitk@ti.com> References: <1377525218-7655-1-git-send-email-balajitk@ti.com> <1377525218-7655-3-git-send-email-balajitk@ti.com> Message-ID: <52415E41.7050301@baylibre.com> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org + Sekhar Hi Balaji, On 26/08/2013 15:53, Balaji T K wrote: > Add mmc2 dt node to dra7-evm board > and model eMMC vcc as fixed regulator. > > Signed-off-by: Balaji T K > --- > arch/arm/boot/dts/dra7-evm.dts | 14 ++++++++++++++ > 1 files changed, 14 insertions(+), 0 deletions(-) > > diff --git a/arch/arm/boot/dts/dra7-evm.dts b/arch/arm/boot/dts/dra7-evm.dts > index a59bbd0..2062724 100644 > --- a/arch/arm/boot/dts/dra7-evm.dts > +++ b/arch/arm/boot/dts/dra7-evm.dts > @@ -17,6 +17,13 @@ > device_type = "memory"; > reg = <0x80000000 0x60000000>; /* 1536 MB */ > }; > + > + mmc2_3v3: fixedregulator-mmc2 { > + compatible = "regulator-fixed"; > + regulator-name = "mmc2_3v3"; > + regulator-min-microvolt = <3300000>; > + regulator-max-microvolt = <3300000>; > + }; > }; > > &dra7_pmx_core { > @@ -257,3 +264,10 @@ > vmmc-supply = <&ldo1_reg>; > bus-width = <4>; > }; > + > +&mmc2 { > + status = "okay"; > + vmmc-supply = <&mmc2_3v3>; > + bus-width = <8>; > + ti,non-removable; Sekhar just posted a series to replace that with a non-TI attribute: non-removable. I'm not sure if this got merged, but it might be good to use the standard attribute instead. Regards, Benoit