From: swarren@wwwdotorg.org (Stephen Warren) Date: Thu, 26 Sep 2013 17:21:21 -0600 Subject: [PATCH 1/2] dts: socfpga: Add ethernet support on Altera's SOCFPGA platform In-Reply-To: <1380057120-27108-1-git-send-email-dinguyen@altera.com> References: <1380057120-27108-1-git-send-email-dinguyen@altera.com> Message-ID: <5244C171.2040705@wwwdotorg.org> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org On 09/24/2013 03:11 PM, dinguyen at altera.com wrote: > From: Dinh Nguyen > > The STMMAC Ethernet controller in SOCFPGA requires setting a register for > the phy-mode that is outside of the ethernet IP. This register resides in > the System Manager block. So we define a new DTS binding > "altr,sysmgr-phy-mask". This binding's property is a bitmask that can be > used to set the correct register bit. > diff --git a/Documentation/devicetree/bindings/net/stmmac-altr-socfpga.txt b/Documentation/devicetree/bindings/net/stmmac-altr-socfpga.txt > +* altr,sysmgr-phy-mask: This property contains the bitmask that is needed to > + set the appropriate register bits for the phy-mode in the System Manager. > + The value should be: > + -Ethernet Controller 1 (gmac0) = 0x3 > + -Ethernet Controller 2 (gmac1) = 0xC Wouldn't you need a phandle to the sysmgr node so that the driver could be located, and a register number within its register block too? Or, does sysmgr know which register to poke? If so, couldn't the API take just a device index rather than a bitmask instead, and calculate the mask itself?