From: bcousson@baylibre.com (Benoit Cousson) Date: Fri, 04 Oct 2013 15:01:44 +0200 Subject: [PATCH 1/2] ARM: dts: am335x-bone-common: correct mux mode for cmd line In-Reply-To: <1380281710-12728-1-git-send-email-balajitk@ti.com> References: <1380281710-12728-1-git-send-email-balajitk@ti.com> Message-ID: <524EBC38.60306@baylibre.com> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org Hi Balaji, On 27/09/2013 13:35, Balaji T K wrote: > pinmux_emmc_pins: mux mode for cmd line should be MODE2 > to detect eMMC on beagle bone black and beagle bone white + eMMC cape. > > Signed-off-by: Balaji T K > Tested-by: Felipe Balbi > --- > based on git://git.kernel.org/pub/scm/linux/kernel/git/bcousson/linux-omap-dt.git for_3.13/dts > > arch/arm/boot/dts/am335x-bone-common.dtsi | 2 +- > 1 files changed, 1 insertions(+), 1 deletions(-) > > diff --git a/arch/arm/boot/dts/am335x-bone-common.dtsi b/arch/arm/boot/dts/am335x-bone-common.dtsi > index ff5c3ca..51f6a99 100644 > --- a/arch/arm/boot/dts/am335x-bone-common.dtsi > +++ b/arch/arm/boot/dts/am335x-bone-common.dtsi > @@ -153,7 +153,7 @@ > emmc_pins: pinmux_emmc_pins { > pinctrl-single,pins = < > 0x80 (PIN_INPUT_PULLUP | MUX_MODE2) /* gpmc_csn1.mmc1_clk */ > - 0x84 (PIN_INPUT_PULLUP | MUX_MODE1) /* gpmc_csn2.mmc1_cmd */ > + 0x84 (PIN_INPUT_PULLUP | MUX_MODE2) /* gpmc_csn2.mmc1_cmd */ > 0x00 (PIN_INPUT_PULLUP | MUX_MODE1) /* gpmc_ad0.mmc1_dat0 */ > 0x04 (PIN_INPUT_PULLUP | MUX_MODE1) /* gpmc_ad1.mmc1_dat1 */ > 0x08 (PIN_INPUT_PULLUP | MUX_MODE1) /* gpmc_ad2.mmc1_dat2 */ > Thanks, I'll apply it for 3.13. Regards, Benoit