From: tomi.valkeinen@ti.com (Tomi Valkeinen) Date: Fri, 25 Oct 2013 14:46:01 +0300 Subject: [PATCH 3/3] ARM: OMAP2: omap4-sdp: remove unneeded gpios from dss-common In-Reply-To: <526A528C.2020204@ti.com> References: <1382695658-18757-1-git-send-email-tomi.valkeinen@ti.com> <1382695658-18757-3-git-send-email-tomi.valkeinen@ti.com> <526A4585.30403@ti.com> <526A4708.7010309@ti.com> <526A4DEA.3050505@ti.com> <526A528C.2020204@ti.com> Message-ID: <526A59F9.3010104@ti.com> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org On 25/10/13 14:14, Nishanth Menon wrote: > lcd2_pins: pinmux_lcd2_pins { > + pinctrl-single,pins = < > + 0x20 (PIN_OUTPUT_PULLDOWN | MUX_MODE3) /* gpio_40 */ > + 0x46 (PIN_OUTPUT_PULLUP | MUX_MODE3) /* gpio_59 */ > + 0x56 (PIN_OUTPUT_PULLDOWN | MUX_MODE3) /* gpio_104 */ > + >; > > 3 pins are driven around 300uA at boot, even with display OFF -> which > means wasted current that could have been optimized by hooking the pin > to the dts node corresponding to the device and used by the driver > appropriately. One more clarification question. The gpio 40 is used to enable powers for the picodlp. Shouldn't that one have a pinctrl pull-down in any case? If it's left floating, and the driver is not compiled in or doesn't start, the powers could get enabled depending on sunspot, right? And I guess the same goes for all gpios used to enable something. Tomi -------------- next part -------------- A non-text attachment was scrubbed... Name: signature.asc Type: application/pgp-signature Size: 901 bytes Desc: OpenPGP digital signature URL: