From: troy.kisky@boundarydevices.com (Troy Kisky) Date: Fri, 22 Nov 2013 12:26:45 -0700 Subject: [PATCH V2 1/6] ahci: imx: Explicitly clear IMX6Q_GPR13_SATA_MPLL_CLK_EN In-Reply-To: <1385118304-27435-1-git-send-email-marex@denx.de> References: <1385118304-27435-1-git-send-email-marex@denx.de> Message-ID: <528FAFF5.9040404@boundarydevices.com> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org On 11/22/2013 4:04 AM, Marek Vasut wrote: > We must clear this IMX6Q_GPR13_SATA_MPLL_CLK_EN bit on i.MX6Q, otherwise > Linux will fail to find the attached drive on some boards. > > This entire fix was: > Reported-by: Eric Nelson > > Signed-off-by: Marek Vasut > Cc: Shawn Guo > Cc: Richard Zhu > Cc: Tejun Heo > Cc: Linux-IDE > --- > drivers/ata/ahci_imx.c | 3 ++- > 1 file changed, 2 insertions(+), 1 deletion(-) > > V2: Update the value in the comment from 0x7ffffffd to 0x7ffffffe > > diff --git a/drivers/ata/ahci_imx.c b/drivers/ata/ahci_imx.c > index ae2d73f..14227d1 100644 > --- a/drivers/ata/ahci_imx.c > +++ b/drivers/ata/ahci_imx.c > @@ -113,7 +113,7 @@ static int imx6q_sata_init(struct device *dev, void __iomem *mmio) > /* > * set PHY Paremeters, two steps to configure the GPR13, > * one write for rest of parameters, mask of first write > - * is 0x07fffffd, and the other one write for setting > + * is 0x07fffffe, and the other one write for setting 0x07ffffff, d+2 = f, bit 1 is IMX6Q_GPR13_SATA_MPLL_CLK_EN, which you just added bit 0 is IMX6Q_GPR13_SATA_TX_EDGE_RATE, which is also in your expression > * the mpll_clk_en. > */ > regmap_update_bits(imxpriv->gpr, 0x34, IMX6Q_GPR13_SATA_RX_EQ_VAL_MASK > @@ -125,6 +125,7 @@ static int imx6q_sata_init(struct device *dev, void __iomem *mmio) > | IMX6Q_GPR13_SATA_TX_BOOST_MASK > | IMX6Q_GPR13_SATA_TX_LVL_MASK > | IMX6Q_GPR13_SATA_TX_EDGE_RATE > + | IMX6Q_GPR13_SATA_MPLL_CLK_EN > , IMX6Q_GPR13_SATA_RX_EQ_VAL_3_0_DB > | IMX6Q_GPR13_SATA_RX_LOS_LVL_SATA2M > | IMX6Q_GPR13_SATA_RX_DPLL_MODE_2P_4F