From: swarren@wwwdotorg.org (Stephen Warren) Date: Wed, 04 Dec 2013 09:57:29 -0700 Subject: [PATCH v2] ARM: tegra: switch FUSE clock on before usage In-Reply-To: References: <1385001613-19098-1-git-send-email-acourbot@nvidia.com> <528E6D58.6050503@wwwdotorg.org> <528EB4EE.309@nvidia.com> Message-ID: <529F5EF9.5010707@wwwdotorg.org> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org On 12/04/2013 12:09 AM, Alexandre Courbot wrote: > Hi Stephen, > > On Fri, Nov 22, 2013 at 10:35 AM, Alex Courbot wrote: >> On 11/22/2013 05:30 AM, Stephen Warren wrote: >>> >>> On 11/20/2013 07:40 PM, Alexandre Courbot wrote: >>>> >>>> FUSE clock is enabled by most bootloaders, but we cannot expect it to be >>>> on in all contexts (e.g. kexec). >>>> >>>> Ensure the FUSE clock is enabled before any of its registers is touched. >>>> Since FUSE is touched very early during system boot (before the clock >>>> devices are registered), directly manipulate the clock register bit in >>>> case the clock device cannot be acquired. >>> >>> >>> This looks reasonable to me. I'll apply it soon after -rc1. >> >> >> Thanks. Be careful as I noticed I misformatted my commit message. The part >> after the "--" will not be stripped by git am as I intended it to be. I >> understood what I did wrong and will hopefully not make that mistake again. >> >> Sorry for the inconvenience. > > I am not seeing this in your tree, have you applied it somewhere already? I haven't applied anything for 3.14 yet. I was hoping to get the DMA/clock/reset DT binding rework in first, but it's been dragging on for while, so I'll probably take a look at what can be applied without conflicting with that soon.