From: swarren@wwwdotorg.org (Stephen Warren) Date: Wed, 04 Dec 2013 22:24:31 -0700 Subject: [PATCH] ARM: bcm2835: add USB controller to device tree In-Reply-To: <1386131536-21066-1-git-send-email-swarren@wwwdotorg.org> References: <1386131536-21066-1-git-send-email-swarren@wwwdotorg.org> Message-ID: <52A00E0F.8070303@wwwdotorg.org> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org On 12/03/2013 09:32 PM, Stephen Warren wrote: > The BCM2835 SoC contains a DWC2 USB controller. Add this to the DT. > > Set up the pin controller to fully enable the USB controller on the > Raspberry Pi. The GPIO setup works because the default output value for > GPIO 6 (LAN_RUN/n_reset) just happens to be 1, which enables the > USB/LAN chip. > > Note that you'll need a U-Boot which enables power to the USB controller; > search for U-Boot patch "ARM: rpi_b: power on SDHCI and USB HW modules". I've applied this to bcm2835's for-3.14/dt branch.