From: alex.shi@linaro.org (Alex Shi) Date: Tue, 10 Dec 2013 16:44:58 +0800 Subject: questions of cpuidle In-Reply-To: <52A6C24B.3030800@linaro.org> References: <52A5C846.30308@linaro.org> <52A5D0E0.7050201@linaro.org> <52A6B5BB.3060506@linaro.org> <52A6C24B.3030800@linaro.org> Message-ID: <52A6D48A.4000507@linaro.org> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org On 12/10/2013 03:27 PM, Daniel Lezcano wrote: > >> And does the wake up pass via GIC to CPU? If so, does the GIC need >> keep awake when all cpu idle? If not, how the firmware give the >> interrupt to CPU? And I am wondering if the deep idle cpu voltage get >> to near 0. How the cpu get the interrupt signal? > > If a deep idle state powers down the GIC, it is up to the PMU to proxy > the interrupts. When an interrupt occurs, the PMU powers up the logic, > including the GIC. The notifier call chain with cpu_suspend / cpu_resume > will save and restore the GIC registers. > > But this is hardware specific and will depend on how the PMU is > implemented and how far it goes in the power management. > > You have a good example in the drivers/cpuidle/cpuidle-ux500.c to > understand with the comments how the interrupts are handled through the > power management unit. > > In the Xillinx documentation available on the web [1], the chapter 24.4 > gives the information about one kind of PMU. > > I believe the mechanism is pretty similar on all the hardware but it is > obfuscated by a generic power instruction like mwait. > > -- Daniel > > [1] > http://www.xilinx.com/support/documentation/user_guides/ug585-Zynq-7000-TRM.pdf > Thanks a lot, Daniel. You are a expert of ARM cpu idle! :) -- Thanks Alex