From: santosh.shilimkar@ti.com (Santosh Shilimkar) Date: Tue, 17 Dec 2013 15:50:40 -0500 Subject: [PATCH 0/4] ARM: keystone: enable GPIO support In-Reply-To: <1387211981-26045-1-git-send-email-grygorii.strashko@ti.com> References: <1387211981-26045-1-git-send-email-grygorii.strashko@ti.com> Message-ID: <52B0B920.1000001@ti.com> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org On Monday 16 December 2013 11:39 AM, Grygorii Strashko wrote: > This series adds Keystone GPIO IP definition in DT and enable GPIO support in > Keystone configuration file. > > Also, it enables LEDs support for Keystone 2 K2H EVM as specified in board > schematic. For more information see: > - http://www.advantech.com/Support/TI-EVM/EVMK2HX.aspx > > Depends on: > [PATCH 0/2] gpio: davinci: reuse for keystone arch > - https://lkml.org/lkml/2013/12/12/366 > > Grygorii Strashko (4): > arm: dts: keystone: add GPIO device entry > ARM: keystone_defconfig: enable gpio support > arm: dts: keystone-evm: add LEDs supports > ARM: keystone_defconfig: enable LED support > Patch subjects should be consistent. I will fix them while applying it on my tree. Will wait for the GPIO driver support patches state before applying the subject series. Thanks for the patches. Regards, Santosh