From: Eugen.Hristev at microchip.com Date: Wed, 15 May 2019 06:42:29 +0000 Subject: [U-Boot] [PATCH 1/3] board: atmel: sama5d2_icp: add periph reset in SPL hw init In-Reply-To: <1557320006-5768-1-git-send-email-eugen.hristev@microchip.com> References: <1557320006-5768-1-git-send-email-eugen.hristev@microchip.com> Message-ID: <538d4255-2f75-79be-918f-2230ba6f63eb@microchip.com> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de On 08.05.2019 15:58, Eugen Hristev - M18282 wrote: > From: Eugen Hristev > > Some periphs on the board need to be reset by holding their reset GPIO down > for a specific time period. > On a warm reset, the periphs are not being reset by any reset pin and may be > in a wrong state. > Reset them in the SPL to make sure we are booting into the correct state > machine of the specific board periphs (KSZ eth switch, USB hub, HSIC eth, > Ethercat) > > Signed-off-by: Eugen Hristev > --- Applied all 3 patches to u-boot-atmel/master