From: hauke@hauke-m.de (Hauke Mehrtens) Date: Sat, 27 Sep 2014 10:33:37 +0200 Subject: [PATCH] bcma: use device from DT (brcm,bus-gpio) for SoC GPIO chip In-Reply-To: References: <1411741733-13888-1-git-send-email-zajec5@gmail.com> <2539898.4te2VKk57a@wuerfel> Message-ID: <54267661.5000401@hauke-m.de> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org On 09/27/2014 10:05 AM, Rafa? Mi?ecki wrote: > On 27 September 2014 00:03, Arnd Bergmann wrote: >> On Friday 26 September 2014 16:28:53 Rafa? Mi?ecki wrote: >>> +The top-level axi bus may contain following children: >>> + >>> +- gpio: GPIO chip on the SoC >>> + >>> + Required properties: >>> + - compatible: "brcm,bus-gpio" >>> + - gpio-controller : makes the node a GPIO controller >>> + - #gpio-cells : size of the GPIO specifier, must be 2 >>> + >>> >> >> I wonder if it would be better to avoid the subnode here and just >> make the parent itself the gpio controller. >> >> Is the gpio controller part of the bus itself in reality, or is it >> a device that gets probed on the bus? > > I'm not sure how to treat this chip. > We control GPIOs using ChipCommon regs (and ChipCommon is one of > cores/devices on the bus), so you could also consider GPIO chip a > sub-device of ChipCommon. > I believe every Broadcom bus has a GPIO chip. In the ancient (MIPS) > times, even if we didn't have ChipCommon, there was an EXTIF core that > used to provide access to the GPIO chip. > > What do you think? Should I make it separated device, even it if > depends on the SoC and its ChipCommon core (device)? > I would make GPIO a subdevive of chipcommon. The chipcommon core has an own IRQ which is also used for GPIO. Hauke