From: Guenter Roeck Date: Sat, 20 Dec 2014 03:23:23 +0000 Subject: Re: [lm-sensors] [PATCH v7 0/5] hwmon: ina2xx: implement chip reinitialization and add new attribute Message-Id: <5494EBAB.5080205@roeck-us.net> List-Id: References: <1418488041-7433-1-git-send-email-bgolaszewski@baylibre.com> In-Reply-To: <1418488041-7433-1-git-send-email-bgolaszewski@baylibre.com> MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: Bartosz Golaszewski Cc: LKML , Benoit Cousson , Patrick Titiano , LM Sensors On 12/13/2014 08:27 AM, Bartosz Golaszewski wrote: > This series implements a mechanism to detect if the chip is in its POR state > and reinitialize it if needed. It also extends the sysfs interface to make the > driver configurable at run-time. > > The shunt_resistor attribute allows to change the shunt resistance value > at run-time in cases where ina2xx used to do the measurement isn't integrated > with the shunt. > > The avg_rate attribute allows to increase/decrease noise reduction. > > v7: > - implemented a retry counter for the reinitialization procedure > - using msleep() (since the sleep is > 20ms) instead of mdelay() > when waiting for the chip update > > v6: > https://www.mail-archive.com/linux-kernel%40vger.kernel.org/msg787390.html > > Bartosz Golaszewski (5): > hwmon: ina2xx: reinitialize the chip in case it's been reset > hwmon: ina2xx: remove a stray new line > hwmon: ina2xx: don't accept shunt values greater than the calibration factor > hwmon: ina2xx: make shunt resistance configurable at run-time > hwmon: ina2xx: allow to change the averaging rate at run-time > > Documentation/hwmon/ina2xx | 8 +- > drivers/hwmon/ina2xx.c | 304 +++++++++++++++++++++++++++++++++++++++------ > 2 files changed, 269 insertions(+), 43 deletions(-) > I didn't forget those patches; I have been busy in the last couple of weeks. Also, I'll be out for the next two weeks. I'll look into the patches after I am back. Guenter _______________________________________________ lm-sensors mailing list lm-sensors@lm-sensors.org http://lists.lm-sensors.org/mailman/listinfo/lm-sensors