From: sergei.shtylyov@cogentembedded.com (Sergei Shtylyov) Date: Fri, 29 Jan 2016 23:49:42 +0300 Subject: [PATCH] ARM: dts: porter: add MAX3355 support In-Reply-To: <56ABCB69.1070800@cogentembedded.com> References: <1674850.BZpGW9kEud@wasted.cogentembedded.com> <4506196.xOgpYRO52t@wasted.cogentembedded.com> <56ABCB69.1070800@cogentembedded.com> Message-ID: <56ABD066.7020804@cogentembedded.com> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org On 01/29/2016 11:28 PM, Sergei Shtylyov wrote: >>> From: linux-renesas-soc-owner at vger.kernel.org >>> [mailto:linux-renesas-soc-owner at vger.kernel.org] On Behalf Of Sergei >>> Shtylyov >>> Sent: Wednesday, January 27, 2016 7:14 AM >>> >>> Now that Maxim Integrated MAX3355 'extcon' driver and device tree bindings >>> are upstream along with the 'extcon' hook in the Renesas USBHS driver, we >>> can add MAX3355 device node to the Porter device tree and properly refer >>> to it from the USBHS node instead of using "renesas,enable-gpio" property >>> which only allowed checking the USB ID pin at the driver probe time; now >>> this pin's state can be monitored dynamically! >>> >>> Signed-off-by: Sergei Shtylyov >> >> I tested this patch on Porter, but interrupt of "usb-otg" didn't happened >> even if I connected/disconnected a usb convert cable (usb micro-ab to A). >> Remarks: I confirmed that the usb convert cable worked correctly on other >> board. > > I guess I have the same cable No, I have mini-AB connector here and hence my cable is mini-AB to A. > and IRQs do happen for me when I connect and > disconnect it (as it should be). >> Best regards, >> Yoshihiro Shimoda MBR, Sergei