From: Marc Dietrich Subject: power class selection failed warning Date: Sat, 27 Jul 2013 16:13:56 +0200 Message-ID: <59782679.nKg2SBZ8OK@ax5200p> Mime-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7Bit Return-path: Received: from mout.gmx.net ([212.227.15.15]:60702 "EHLO mout.gmx.net" rhost-flags-OK-OK-OK-OK) by vger.kernel.org with ESMTP id S1751586Ab3G0OOl (ORCPT ); Sat, 27 Jul 2013 10:14:41 -0400 Received: from ax5200p.localnet ([217.229.199.90]) by mail.gmx.com (mrgmx002) with ESMTPSA (Nemesis) id 0M8edX-1U6q7A1d59-00wFaA for ; Sat, 27 Jul 2013 16:14:39 +0200 Sender: linux-mmc-owner@vger.kernel.org List-Id: linux-mmc@vger.kernel.org To: linux-mmc@vger.kernel.org Hi, since 3.11-something, I get "power class selection to bus width 8 failed" during boot. This is the same device as described here already [1], but this time it is non-fatal, because it's just a warning. Since I reported [1], I was thinking about the origin of this problem and found that the eMMC announces two voltage caps, but the board wired both supplies vmm and qvmm to the same voltage supply, so the eMMC may report error on powerclass switch - at least that's my interpretation. If the interpretation above is right, is there any way to avoid this warning (e.g. check the voltages of the regulator supplies). Thanks! Marc [1] http://marc.info/?l=linux-mmc&m=133434010207837&w=2