From: raj reddy Date: Wed, 12 Sep 2007 12:36:42 +0100 (BST) Subject: [U-Boot-Users] Atmel AT49BV320C support in Uboot In-Reply-To: <20070911203542.85F0D247CE@gemini.denx.de> Message-ID: <617544.32853.qm@web7712.mail.in.yahoo.com> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de --- Wolfgang Denk wrote: > In message > <926455.96023.qm@web7701.mail.in.yahoo.com> you > wrote: i am getting the following error while i tried to save the environment data.....why not i can save????? I2C: ready DRAM: 16 MB FLASH: 4 MB *** Warning - bad CRC, using default environment In: serial Out: serial Err: serial Net: No ethernet found. Type "run flash_nfs" to mount root filesystem over NFS Hit any key to stop autoboot: 0 => => saveenv Saving Environment to Flash... Error: cannot span across banks when they are mapped in reverse order Error: cannot span across banks when they are mapped in reverse order Protected 37 sectors => Thanks, Raj. > > I tried to use the CFI driver by adding the CFI > macros > > in the .h file. But the size of my flash is 2MB, > but > > it shows 4MB. > > So you misconfigured something... > > > I have one doubt, in the board .h file we specify > the > > sectore size. what size i must give the sector > size in > > board .h file. > > The CFI driver will auto-detect the sector sizes. > You must confuse > something here.. Which exact #define are you talking > about? > > Best regards, > > Wolfgang Denk > > -- > DENX Software Engineering GmbH, MD: Wolfgang > Denk & Detlev Zundel > HRB 165235 Munich, Office: Kirchenstr.5, D-82194 > Groebenzell, Germany > Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 > Email: wd at denx.de > "Have you lived in this village all your life?" > "No, not yet." > Try the revolutionary next-gen Yahoo! Mail. Go to http://mrd.mail.yahoo.com/dc/landing