From: miller69@gmx.net Date: Mon, 15 Mar 2004 21:03:20 +0000 Subject: Re: [LARTC] Bridge + TC Message-Id: <6500.1079384600@www53.gmx.net> List-Id: References: <40559064.6000400@rogers.com> In-Reply-To: <40559064.6000400@rogers.com> MIME-Version: 1.0 Content-Type: text/plain; charset="iso-8859-1" Content-Transfer-Encoding: quoted-printable To: lartc@vger.kernel.org Hi, > I have also tried that. I'm using 2.6.3-mm3 -> packets don't seem to=20 > Perhaps the key here is 2.4. I might have to revert... There was a change with kernel 2.6.0 for incoming and outgoing interfaces of a bridge device (at least for iptables - that's why I'm guessing it also affects ebtables): > ebtables -A FORWARD -i eth1 -j mark --set-mark 0x1 > ebtables -A FORWARD -i eth2 -j mark --set-mark 0x2 Well for iptables a similar rule would look like: iptables -A FORWARD -i eth1 -j MARK --set-mark 0x1 If eth1 is a port of a bridge you have to use with 2.6.x this: iptables -A FORWARD -m physdev --physdev-in eth1 -j MARK --set-mark 0x1 Having a closer look at this may help solving your problem? Regards, =20 --=20 +++ NEU bei GMX und erstmalig in Deutschland: T=DCV-gepr=FCfter Virenschutz= +++ 100% Virenerkennung nach Wildlist. Infos: http://www.gmx.net/virenschutz _______________________________________________ LARTC mailing list / LARTC@mailman.ds9a.nl http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/