From: Patricio Moreno Date: Mon, 18 Jul 2022 11:51:54 +0000 Subject: Usage of ads117x driver Message-Id: <7d341a03-976a-32c6-8ba1-87b169408bfa@gmail.com> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: linux-sound@vger.kernel.org Hello everyone. I'm trying to use the ads117x driver (sound/soc/codecs/ads117x.c) but I can't get any output on the I2S of the board I'm using (a verdin imx8mm module mounted on a Toradex Verdin Development Board). The ads117x is an ADC driver with a FRAME/SYNC interface, it's not a sound card. Now I'm doubting if I've understood correctly the I2S interface. I'm testing without connecting the ADC to the board, as I understand the I2S master should generate the BCLK and SYNC signals even if the adc is not connected (and these are what I'm trying to see with a logic analyzer). I'm setting the following on the dts: adc: adc { compatible = "simple-audio-card"; simple-audio-card,name = "ti-ads117x"; bitclock-master = <&ads117x_codec>; frame-master = <&ads117x_codec>; simple-audio-card,routing "Input1", "Capture", "Input2", "Capture", "Input3", "Capture", "Input4", "Capture", "Input5", "Capture", "Input6", "Capture", "Input7", "Capture", "Input8", "Capture"; simple-audio-card,dai-link { format = "left_j"; bitclock-master = <&ads117x_codec>; frame-master = <&ads117x_codec>; cpu { sound-dai = <&sai5>; dai-tdm-slot-num = <8>; dai-tdm-slot-width = <24>; }; ads117x_codec: codec { sound-dai = <&ads117x 0>; clocks = <&clk IMX8MM_CLK_SAI5_ROOT>; }; }; }; ads117x: codec-ads117x@0 { compatible = "ti,ads117x"; #sound-dai-cells = <0>; status = "okay"; }; Could I get some indications if this is the correct path? Thank you! PS: the actual ADC is the ads1278, which is a drop-in replacement for the ads1178, but with 24 bit samples instead of 16 bit samples. PS2: I've tried with the IIO subsystem, using SPI, but at 25 MHz it's impossible not to lose samples (without using some other approach I did not yet try).