From: gregory.clement@bootlin.com (Gregory CLEMENT) Date: Fri, 21 Sep 2018 16:15:42 +0200 Subject: [RESEND PATCH 4/4] arm64: dts: marvell: add thermal-zone node in cp110 DTSI file In-Reply-To: <20180830081501.11569-4-miquel.raynal@bootlin.com> (Miquel Raynal's message of "Thu, 30 Aug 2018 10:15:01 +0200") References: <20180830081501.11569-1-miquel.raynal@bootlin.com> <20180830081501.11569-4-miquel.raynal@bootlin.com> Message-ID: <87bm8rgcmp.fsf@bootlin.com> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org Hi Miquel, On jeu., ao?t 30 2018, Miquel Raynal wrote: > Add a thermal-zone node and fill in all the sensors available in a > cp110 (only one in the thermal IP). > > Signed-off-by: Miquel Raynal Applied on mvebu/dt64 Thanks, Gregory > --- > arch/arm64/boot/dts/marvell/armada-cp110.dtsi | 19 +++++++++++++++++++ > 1 file changed, 19 insertions(+) > > diff --git a/arch/arm64/boot/dts/marvell/armada-cp110.dtsi b/arch/arm64/boot/dts/marvell/armada-cp110.dtsi > index 62842fae2571..d9b50ad0bc6c 100644 > --- a/arch/arm64/boot/dts/marvell/armada-cp110.dtsi > +++ b/arch/arm64/boot/dts/marvell/armada-cp110.dtsi > @@ -6,6 +6,7 @@ > */ > > #include > +#include > > #include "armada-common.dtsi" > > @@ -19,6 +20,23 @@ > * save one indentation level > */ > CP110_NAME: CP110_NAME { }; > + > + /* > + * CPs only have one sensor in the thermal IC. > + * > + * The cooling maps are empty as there are no cooling devices. > + */ > + thermal-zones { > + CP110_LABEL(thermal_ic): CP110_NODE_NAME(thermal-ic) { > + polling-delay-passive = <1000>; > + polling-delay = <1000>; > + > + thermal-sensors = <&CP110_LABEL(thermal) 0>; > + > + trips { }; > + cooling-maps { }; > + }; > + }; > }; > > &CP110_NAME { > @@ -226,6 +244,7 @@ > CP110_LABEL(thermal): thermal-sensor at 70 { > compatible = "marvell,armada-cp110-thermal"; > reg = <0x70 0x10>; > + #thermal-sensor-cells = <1>; > }; > }; > > -- > 2.17.1 > -- Gregory Clement, Bootlin Embedded Linux and Kernel engineering http://bootlin.com